針對環氧地坪漆施工前,基層缺陷的處理方式。一個高質量的無錫環氧地坪受多種因素影響。其中就有地面基層,基層的好壞決定了環氧地坪質量的高低。因此對于基層缺陷要進行積極有效的處理。俗話說,磨刀不誤砍柴工。不先把基層問題解決好,怎么進行環氧地坪施工,怎么能打造出高質量的成都環氧地坪。下面環氧地坪漆施工針對一些基層缺陷問題提出的解決方案。
Aiming at the treatment of base defects before construction of epoxy floor paint. A high quality floor is affected by many factors. Among them, there is the ground base. The quality of the base determines the quality of the floor. Therefore, the grass-roots defects should be dealt with actively and effectively. As the saying goes, sharpening knives does not mistake wood cutters. Without solving the problems at the grass-roots level, how to carry out the construction of epoxy flooring and how to create a high-quality epoxy flooring in Chengdu. The following epoxy floor paint construction for some grass-roots defects of the solution.
一、基層地面上附著物的處理
1. Disposal of attachments on the ground at the grass-roots level
在基層表面上,因為施工原因,會留下許多附著物,例如:水泥地上的水泥疙瘩、砂粒和浮漿等,這些基層附著物在進行環氧底漆施工前需要用磨光機或鏟刀等施工工具清除干凈。
On the surface of the base, because of construction reasons, many attachments will be left, such as cement bumps, sand particles and floating slurry on the cement ground. These attachments need to be cleaned by polishing machine or shovel blade before epoxy primer construction.
還有一些基層伸縮縫中填補的是瀝青,需要把瀝青挖出,然后用環氧砂漿進行填補,最后用金屬抹刀抹至和周圍基層一樣的水平。
Some base expansion joints are filled with asphalt, which needs to be digged out, filled with epoxy mortar, and finally wiped to the same level as the surrounding base with a metal spatula.
環氧地坪漆施工前對基層缺陷的處理方法
Treatment Method of Base Defects before Construction of Epoxy Floor Paint
二、油污的處理
II. Treatment of Oil Pollution
尤其是工業地坪中,油污污染是最嚴重的,基層混凝土的毛孔都被油污給堵塞了,環氧地坪漆不能滲入,會影響漆膜和地坪的附著力,即便做好成都環氧地坪,也會出現縮孔等現象。所以需要進行油污處理,油污少的區域,直接用清潔劑清洗干凈即可。油污較多的區域,建議用汽油或酒精燃燒方法祛除。以上方法處理都不理想的情況下,建議重新做混凝土。
Especially in industrial floors, oil pollution is the most serious. The pore of base concrete is blocked by oil pollution. Epoxy flooring paint can not penetrate, which will affect the adhesion of paint film and flooring. Even if the epoxy flooring in Chengdu is well done, shrinkage and other phenomena will occur. So we need to deal with oil pollution. If there is less oil pollution, we can clean it directly with detergent. In areas with more oil pollution, it is suggested that gasoline or alcohol combustion be used to remove it. In the case that the above methods are not ideal, it is suggested to make concrete again.
三、平整度的處理
3. Treatment of Flatness
無錫環氧地坪對基層的平整度要求較高,對于平整度不達標的區域需要進行修補??捎铆h氧砂漿或其它合適的材料對地面上的坑洞、不平整處進行修補,一遍不行就進行多遍。之后用研磨機、銑刨機修整地面的平整度。
Epoxy flooring requires a high level of leveling of the grass-roots, and needs to be repaired in areas where the leveling does not meet the standards. Epoxy mortar or other suitable materials can be used to repair the pits and irregularities on the ground. If it can't be done once, it can be done many times. Afterwards, grinders and milling machines are used to trim the levelness of the ground.